97201900 Removing and installing wiring harness for centre console

WM 972019 Removing and installing wiring harness for centre console

Preliminary work

Preliminary work for interior monitoring sensor

Remove centre console. -> 681719 Removing and installing centre console - section on "Removing" 681719 Removing and installing centre console

Removing wiring harness for centre console

1. Release electric connectors for the equipment versions (e.g. cigarette lighter, interior sensor etc. -A- and unplug.





Releasing and unplugging connectors

2. Disengage retaining clips with wiring harness on centre console and remove the harness.





Disengaging wiring harness

Installing wiring harness for centre console

Information

The wire harness for centre console spare parts scope means the scope for fully-equipped vehicles. Depending on the vehicle equipment, connectors not required are tied to the wire harness for centre console using tie-wraps.

When doing this, ensure the lines are routed correctly so that no line becomes trapped or damaged.

1. Lay wiring harness with retaining clips in centre console and push on retaining clips at the points provided.





Laying wiring harness

2. Push electric connectors onto equipment versions until they are felt to engage.

Subsequent work

Subsequent work for interior monitoring sensor

Install centre console. -> 681719 Removing and installing centre console - section on "Installing" 681719 Removing and installing centre console