Removing and Installing Gearshift Bracket

Removing and installing gearshift bracket








Preliminary work

1. Remove shift lever knob.
2. Remove centre console.

Removing gearshift bracket

1. Locking bridge P 9619/1 must be fitted on the gearshift bracket.





Fitting locking bridge

2. Open bayonet locks on the pre-selector and shifting connections.





Opening bayonet lock

3. Disengage adjustment pin on pre-selector and shifting connections.





Disengaging shift cables

4. Unclip supports on the gearshift bracket.





Unclipping supports

5. Unscrew nut and lift gearshift bracket up and off.





Removing gearshift bracket

6. Remove locking bridge.





Removing locking bridge

Installing gearshift bracket

1. Fit gearshift bracket and screw in nuts.





Installing gearshift bracket





2. Locking bridge 9619/1 must be fitted on the gearshift bracket.





Fitting locking bridge

3. Clip in supports on the gearshift bracket. The support with the blue hinged tube must be fitted on the left and the support with the black hinged tube must be fitted on the right.





Clipping in supports

Information
Before starting to install the gearshift bracket, ensure that the transmission is in neutral.

4. Engage adjustment pin on pre-selector and shift connections.





Engaging shift cables

5. Close bayonet locks on the pre-selector and shift connections.





Closing bayonet locks

6. Remove locking bridge.





Removing locking bridge

Subsequent work

1. Install centre console.
2. Install shift lever knob.