Removing and Installing Sealing Ring For Input Shaft

WM 355019 Removing and installing sealing ring for input shaft





Preliminary work

Preliminary work
1. Remove transmission.
2. Remove guide sleeve.

Removing sealing ring for input shaft

Removing sealing ring for drive shaft
1. Press guide sleeve on sufficiently and drive sealing ring out of the guide sleeve using a punch.





Installing sealing ring for input shaft

Installing sealing ring for drive shaft
1. Place new sealing ring on side of pressure piece P 9743 with a cut-out.





2. Tap sealing ring into the guide sleeve using a rubber hammer.





Subsequent work

Subsequent work
1. Install guide sleeve.
2. Install transmission.