P2626

P2626

Diagnosis information - DME (DFI)

Oxygen sensor ahead of catalytic converter, bank 1 - pumping voltage line

NOTE: Do not use contact spray on the oxygen sensor's plug connections as this will result in irreparable damage to the lines (blockage of reference air duct).

NOTE: Do not interchange the oxygen sensor ahead of catalytic converter with the sensor behind the catalytic converter as this will result in implausible fault entries.

Diagnostic conditions
- Perform short test [Oxygen sensor active test]

or (if no short test is possible):
- Exhaust temperature more than 200 °C (392 °F)
- Engine at operating temperature
- then drive for 2 minutes (incl. 1 overrun phase)
- then engine idling more than 30 seconds

Possible fault causes
- Open circuit, compensating current
- Oxygen sensor faulty