680719 Removing and installing cover strip (logo)

WM 680719 Removing and installing cover strip (logo)

Tools





Technical values





Removing cover strip





Installation position of cover strip (logo)

1. Heat the side member -1- slightly in the area of the logo -2- using the hot-air blower Nr.155-1 Pos.2 -3- ( -arrows A- ) and pull off the logo -arrow B-.





Removing cover strip (logo)

2. Loosen and remove adhesive residues on the side member using cleaning agent.

Installing cover strip

NOTICE

Decorative films not prepared/fitted correctly

- Damage to decorative films
- Inadequate film adhesion

-> Freshly painted surfaces must be dried fully to ensure that they are completely free of solvents.
-> Carefully clean the areas on which you intend to stick the film to ensure that all traces of oil, grease and silicone are completely removed.
-> Do not touch the bonding surfaces.
-> Only touch adhesive side of logo in the middle and not at the corners or along the edges (if contact is unavoidable).
-> Object (decorative film, vehicle, etc.) and ambient temperature=> Minimum temperature: 15°C.
-> Optimal adhesion of the logo to the vehicle is guaranteed after approx. 48 hours. Do not put any pressure on the logo (e.g. using a car wash) during this period.

Information

General information on affixing the decorative film

- Affix the decorative film at an ambient temperature of between 18 and max. 25 °Celsius.

- The self-adhesive logo will not stick at temperatures below 18° Celsius. The minimum temperature limit of 18° Celsius must be observed.

- Park the vehicle in the workshop beforehand as required so that the vehicle is at the ambient temperature.

- If the ambient temperature is at the minimum temperature limit, the affixed decorative film must be heated well using a hot-air gun immediately after sticking it on.

1. Clean the painted surface (of the vehicle) by washing it with a non-lubricating cleaning agent.
2. Immediately before you stick on the logo, wash off the area on which you intend to stick the film using isopropanol (100%) to ensure that all traces of silicone, grease and oil are completely removed.
3. Pull cover foil -2- off the backing sheet -1- at a 180° angle -arrow-.





Attaching backing sheet

4. Position the backing sheet -1- on the vehicle so that it is centred with respect to the door entry guard -4- and press it on lightly.
The logo -3- cannot be repositioned, so make sure to affix it at the exact position.
5. Press on the backing sheet -1- with a plastic spatula from the inside to the outside to remove air bubbles on the logo -2-.
Make sure there are no bubbles on the backing sheet.





Affixing logo

6. After affixing, pull off the backing sheet -1- ( -arrow- ).





Pulling off backing sheet

7. Check the logo -2- for bubbles and other problems. The logo must be affixed securely to the vehicle.
Check that the corners are affixed correctly. Press them down again if necessary.