611419 Removing and installing water drip pan
WM 611419 Removing and installing water drip pan
Technical values
Preliminary work
Remove cabriolet convertible top. -> 610119 Removing and installing cabriolet convertible top - section on "Removing" 610119 Removing and installing hood
Removing water drip pan
Installation position of water drip pan
1. Remove fastening screw -1- on belt reel -2- and remove belt reel from roll-over bar -arrow-.
Removing belt reel
2. Remove three fastening screws -1- from the convertible top support -2-.
Releasing fastening for convertible top support
CAUTION
Removal of water drip pan
- Material damage (paint damage) to roll-over bar!
-> Avoid using sharp-edged tools when inserting the spacing block between the convertible top support and roll-over bar and when loosening the water drip pan from the roll-over bar.
3. Pull convertible top support -2- out by approx. 10 mm -arrow A- and use a spacing block -3- to secure it between the roll-over bar and the convertible top support -arrow B-.
4. Loosen the water drip pan -1- from the two strips of double-sided adhesive tape -2- close to the fastening for the convertible top support.
Removing water drip pan
5. Pull the water drip pan -1- down and out -arrows- behind the convertible top support -3-.
Installing water drip pan
Installation position of water drip pan
1. Insert the water drip pan -1- behind the convertible top support -2- from below -arrows-.
Installing water drip pan
2. Position the water drip pan -1- on the roll-over bar and press onto the two strips of double-sided adhesive tape -3- close to the fastening for the convertible top support.
CAUTION
Installation of water drip pan
- Material damage (paint damage) to roll-over bar!
-> Avoid using sharp-edged tools when removing the spacing block between the convertible top support and roll-over bar.
3. Remove spacing block -1- between the roll-over bar and convertible-top support -2- ( -arrow A- ).
Securing convertible top support
4. Position convertible top support -2- on the roll-over bar -arrow B- and screw down with the three fastening screws -3-. Tightening torque => Tightening torque: 23 Nm (17 ftlb.)
5. Place the belt reel -1- on the roll-over bar -arrow- , position it correctly and secure with the fastening screw -2-. Tightening torque => Tightening torque: 50 Nm (37 ftlb.)
Installing belt reel
Subsequent work
Install cabriolet convertible top. -> 610119 Removing and installing cabriolet convertible top - section on "Installing" 610119 Removing and installing hood