612119 Removing and installing cover strip

WM 612119 Removing and installing cover strip

Technical values





Preliminary work

Move convertible top to service position. -> 6101IN IN - convertible top service position Procedures

Removing cover strip





Installation position for cover strip

1. Unscrew fastening screws -1- and remove cover strip -2- from roof frame -3-.





Removing cover strip

Installing cover strip





Installation position for cover strip

Information

Seal for convertible-top tip must not be trapped. There must be no gap between seal and covering, and the seal with the covering must run evenly. If necessary, pull the seal up and out and tap it in again.

1. Position cover strip -2- on roof frame -3- and screw down with the fastening screws -1-. Tightening torque => Tightening torque : 3.5 Nm (2.5 ftlb.)





Removing cover strip

Subsequent work

End service position. -> 6101IN IN - convertible top service position Procedures