Turn Signal Bulb: Service and Repair

WM 943555 Replacing light bulb for direction indicator light

Preliminary work

Preliminary work for direction indicator light bulb

-> 94311900 Removing and installing tail light - section on "Removing" 94311900 Removing and installing tail light

Removing light bulb for direction indicator light





Overview of the left tail light.





Information

If the tail light is only removed and installed again, the seal for the tail light can be re-used.

If the seal for the tail light is damaged, this seal must be replaced.

If the seal is removed from the light, this seal must be replaced.

- If necessary: Pull off the seal and carefully clean the sealing face with a knife.

1. Pull off the tail light seal and carefully clean the sealing face with a knife, for example.
2. Pull off the two electric connectors -2- and -3- on the light bulb.





Pulling off connectors and unscrewing fastening screws

3. Unscrew the two fastening screws -4- for the light bulb.
4. Remove light bulb -5- from the tail light.

Installing light bulb for direction indicator light

Information

If the tail light is only removed and installed again, the seal for the tail light can be re-used.

If the seal for the tail light is damaged, this seal must be replaced.

If the seal is removed from the light, this seal must be replaced.

- If necessary: Pull off the seal and carefully clean the sealing face with a knife.

1. Fit light bulb -5- into the tail light.





Plugging in connectors and screwing in fastening screws

2. Screw in the two fastening screws -4- for the light bulb.
3. Connect the two electric connectors -2- and -3- to the light bulb and check that they are seated securely.

Subsequent work

Subsequent work for direction indicator light bulb

-> 94311900 Removing and installing tail light - section on "Installing" 94311900 Removing and installing tail light