705719 Removing and installing A-pillar trim

WM 705719 Removing and installing A-pillar trim

Technical values





Removing A-pillar trim









1. Using a screwdriver, unclip the cap -7- from the A-pillar trim.





2. Unscrew fastening screw -6-.





3. Starting at the fastening bolt -5- at the top, unclip A-pillar trim from the clip connections.





4. Unclip A-pillar trim -1- in an upward direction.






Installing A-pillar trim

Installing A-pillar trim panel





1. Check fastening clips -8- for deformation; replace if necessary.





2. Insert retaining catches -3- on the A-pillar trim -1- into the fastening clips -2- and the instrument panel guide slot.









3. Insert the retaining catch -4- into A-pillar side trim at the bottom.





4. Clip A-pillar trim -1- into A-pillar from bottom to top. Make sure that the fastening bolt reaches into the fastening bore.





5. Screw in fastening screw -6- and tighten to the specified tightening torque. => Tightening torque: 3 ftlb.+0.25 ftlb.





6. Clip cap -7- into A-pillar trim recess.