887819 Removing and Installing Blower Regulator
WM 887819 Removing and installing blower regulator
Technical values
Preliminary work
Remove rear side trim panel. -> 700319 Removing and installing side trim panel for rear luggage compartment - section on "removing" 700319 Removing and installing rear luggage compartment side-trim panel
Removing blower regulator
CAUTION
Danger of damage and injury.
-> Remove ignition key.
-> First pull out the plug contacts on the switch before the fan control is removed.
Overview of fan control
1. Release both electrical connectors -Arrows A- and unplug them -Arrows B-.
Pulling off plug
2. Unscrew the two fastening screws -1- and remove the fan control -Arrow-.
Releasing and removing the fan control
Installing blower regulator
1. Insert the fan control plug in -Arrow- and screw down with the fastening screws -1-. => Tightening torque: 1.0 ftlb.
Installing and screwing down fan control
2. Push in both connectors -Arrows A- until the locking tabs -Arrows B- are felt to engage.
Inserting the connectors
Subsequent work
Install rear side trim panel. -> 700319 Removing and installing side trim panel for rear luggage compartment - section on "installing" 700319 Removing and installing rear luggage compartment side-trim panel