945319 Removing and installing side direction indicator light

WM 945319 Removing and installing side direction indicator light

Preliminary work

1. Release wheel housing liner in the front area. => 505619 Removing and installing front wheel housing liner - section on "Removing"

Removing side direction indicator light





Installation position of side direction indicator light

WARNING

Risk of short circuit.

- Before removing bulb, remove ignition key and switch off light switch.

1. Pull off bulb socket -1- from the direction indicator light -2- ( -arrow- ).





Pulling off bulb socket from direction indicator light

2. Remove side direction indicator light.
2.1. Unscrew fastening screws -1-.
2.2. Release side direction indicator light -2- at the clip -arrow A- and remove to the rear -arrow B-.





Removing side direction indicator light

Installing side direction indicator light

Information

If the lamp bracket is "twisted" in the lamp housing, this can damage the light and/or cause the side direction indicator light to fog up.

- When fitting the bulb socket, make sure that the bulb socket guide is inserted into the groove on the direction indicator light and check that the rubber sleeve is flush with the direction indicator light.

1. Install side direction indicator light.
1.1. Insert side direction indicator light -2- from the rear in -direction of arrow- into the front apron until the clip -arrow- engages securely.
1.2. Tighten fastening screws -1-.





Installing side direction indicator light

2. Push bulb socket -1- onto the direction indicator light -2- ( -arrow- ).





Pushing bulb socket onto direction indicator light

Subsequent work

1. Secure wheel housing liner in the front area. => 505619 Removing and installing front wheel housing liner - section on "Installing"