693619 Removing and installing rear adjustment fitting

WM 693619 Removing and installing rear adjustment fitting

Technical values





Removing rear adjustment fitting and support plate

Removing rear adjustment fitting

WARNING

The support plate with threaded parts will be damaged in the event of impact with seat belt buckled.

- Damage to the support plate can lead to impairment in functional capability of the restraint system and personal injury as a consequence.
- When replacing the safety belt following accident damage, the support plate of the adjustment fitting and the threaded parts must also be replaced for safety reasons.





1. Remove C-pillar trim. -> 706819 Removing and installing C-pillar trim - section on "removing" 706819 Removing and Installing C-Pillar Trim Panel
2. Position adjustment fitting so that the upper fastening screw is accessible.





3. Unscrew fastening screw -1-.





4. Fold adjustment fitting inwards -arrow A- and remove upwards -arrow B-.





Removing support plate for rear adjustment fitting

1. Unscrew fastening screw -1- and remove support plate.






Installing rear adjustment fitting and support plate

Installing support plate for rear adjustment fitting

Information

- For safety reasons, the fastening screw -1- for the adjustment fitting support plate must be replaced after removal.





1. Insert rear support plate. Ensure that the tabs -A- lie inside the spacer sleeves.





2. Screw in the fastening screw -1- so that the top of the support plate can still just be moved.





Installing rear adjustment fitting

CAUTION

Installation of the adjustment fitting

- During installation, the adjustment fitting can get pressed upwards by the reset spring , thereby causing injury.
- When installing the adjustment fitting, please take care to keep your hands and fingers clear of the danger area.
- Wear personal protective gear.

->Information

- For safety reasons, the fastening screw -1- for the adjustment fitting must be replaced after removal.










1. Engage the adjustment fitting on the support plate at the bottom -Arrow A- and fold inwards at the top -Arrow B-.





2. Screw down support plate and adjustment fitting with the fastening screws -1- top and bottom. => Tightening torque: 4.5 Nm (3.5 ftlb.)





3. Install C-pillar trim. -> 706819 Removing and installing C-pillar trim - section on "installing" 706819 Removing and Installing C-Pillar Trim Panel