396119 Removing and Installing Rubber Mounting For Rear Final Drive

WM 396119 Removing and installing rubber mounting for rear final drive

Tools






Preliminary work

Preliminary work, rubber mounting on rear final drive

1. Remove rear final drive. -> 390119 Removing and installing rear final drive - "Removing" section 390119 Removing and installing rear final drive

Removing rubber mounting for rear final drive

Removing rubber mounting for rear final drive, drive side





Rubber mounting, drive side -1-

1. Mark rubber mounting for transmission housing at the installation position -arrow-.





Marking for rubber mounting for housing

2. Position special tool assembly fixture 9716 a/b on rubber mounting => Removal on drive side.





Removal on drive side

3. Remove rubber mounting -direction of arrow-.

Removing rubber mounting for rear final drive, output side





Rubber mounting for output side -2-

1. Remove output flange with special tool striker VW 771/1 and material 00000 -direction of arrow-.





Removing output flange

2. Mark rubber mounting for transmission housing at the installation position -arrow-.





Marking for rubber mounting

3. Position special tool assembly fixture 9716 a/b on rubber mounting => Removing rubber mounting.





Removing rubber mounting

4. Remove rubber mounting -direction of arrow-.

Installing rubber mounting for rear final drive

Installing rubber mounting for rear final drive, output side





Rubber mounting for output side -2-

Information

Noises in drive line

- Installation position of rubber mounting bulge is incorrect Rubber mounting bulge must be installed vertically into housing

- Installation position of mount in housing is incorrect Pay attention to installation dimension of mount to housing

1. Position special tool assembly fixture 9716 a/b/c on rubber mounting and align the markings.





2. Press rubber mounting flush => see figure into housing.





Information

Noises in drive line

- Installation position of rubber mounting bulge is incorrect Rubber mounting bulge must be installed vertically into housing

- Installation position of mount in housing is incorrect Pay attention to installation dimension of mount to housing

3. Install output flange.

Installing rubber mounting for rear final drive, drive side





Rubber mounting, drive side -1-

Information

Noises in drive line

- Installation position of rubber mounting bulge is incorrect Rubber mounting bulge must be installed vertically into housing

- Installation position of mount in housing is incorrect Pay attention to installation dimension of mount to housing

1. Position special tool assembly fixture 9716 a/b/c on rubber mounting => Installing rubber mounting on drive side and align the markings.





Installing rubber mounting on drive side

Information

Noises in drive line

- Installation position of rubber mounting bulge is incorrect Rubber mounting bulge must be installed vertically into housing

- Installation position of mount in housing is incorrect Pay attention to installation dimension of mount to housing

2. Press rubber mounting flush -direction of arrow- into housing.

Subsequent work

Touching up, rubber mounting on rear final drive

1. Install rear final drive. -> 390119 Removing and installing rear final drive - "Installing" section 390119 Removing and installing rear final drive