344919 Removing and installing countershaft cap

WM 344919 Removing and installing countershaft cap

Tools






Preliminary work countershaft cap

1. Remove transmission. -> 343519 Removing and installing transmission - section on "removing" 343519 Removing and installing transmission

Removing countershaft cap





Overview of cap

1. Drive two small holes -figure- - offset by 180 ° - into the sealing ring.





Preparatory work for removing sealing ring

2. Screw two sheetmetal screws into the holes in the cap.





Screwing in sheetmetal screws

3. Remove cap using slide hammer kit nr.168.





Removing sealing ring

Installing countershaft cap





Overview of cap

1. Drive new cap in flush using special tool pressure piece t10180.

Touching up countershaft cap

Reworking countershaft cap

1. Install transmission. -> 343519 Removing and installing transmission - section on "installing" 343519 Removing and installing transmission
2. Check transmission oil. -> 340135 Check and top up transmission oil - Section on "Checking" Procedures