703919 Removing and installing cover for rear lock support

WM 703919 Removing and installing cover for rear lock support

Removing cover for rear lock support





Installation position of rear lock support cover

Information

- To reduce the unclipping forces and thereby the risk of damage during removal, the removal steps must be carried out at the accessible connection points using a suitable tool.

1. Unclip cover -A- and remove it by pulling it upwards -B-.





Unclipping cover

Installing cover for rear lock support

Information

- Check that all the fastening clips are positioned fully and correctly.

- Check that all the fastening clips are not bent or broken.

- Replace damaged or missing clips with new ones.

1. Install cover.





Fitting cover

1.1. Place the cover in installation position and clip it in -A-.
1.2. Pull the lip of the rubber seal forward under the cover -B-.