Removing and Installing Wiring For Electrically Adjustable Seat

Removing And Installing Wiring For Electrically Adjustable Seat

Preliminary work
1. Remove the front seat.

Removing wiring for electrically adjustable seat

NOTE:
Voltage peaks
- Risk of damage to load or to the control unit

- Switch off ignition and remove remote control before disconnecting or removing load.

INFORMATION:
Always comply with the regulations for handling ESD-sensitive components.
- Assembly work must only be carried out if the mechanic is wearing the working clothes and shoes approved by Porsche.
- The new part must only be removed from the ESD (electrostatic discharge) protective packaging just before installation and at the position at which the part is to be installed.
- Never touch the electric pins and plug contacts.

INFORMATION: The number of plug connections can vary, depending on equipment.







1. Unclip bracket at the seat frame -1-.







2. Unscrew fastening screw -1- and unclip bracket -2-.







3. Take cable conduit -1- out of the brackets -2 + 3-.







4. Remove the split cable conduit -1- and expose the wire harness -2- as far as the cable sheathing.







5. Remove tie-wrap -2- on the connector socket -1-.







6. Release single connectors -3- ( -A- ) and remove them from the connector socket -1- ( -B- ).
7. Remove all relevant tie-wraps -1- and clips -2-.







8. Release and unplug electric plug connections -1-.







Installing wiring for electrically adjustable seat

INFORMATION:
- The number of plug connections can vary, depending on equipment.
- When routing the wire harness, make sure that it is routed without tension.

1. Plug in and lock electric plug connections -1-.







2. Fit all relevant tie-wraps -1- and clips -2-.







3. Plug the single connectors -2- into the connector socket -1- and check that the lock engages securely.







4. Fit tie-wrap -3- on the connector socket.
5. Fit cable sheathing -1-.







6. Route wire harness -2- in the cable conduit and fit the split cable conduit -1-.







7. Clip cable conduit -1- into the brackets -2 + 3-.







8. Clip in bracket -2- and screw in fastening screw -1-.







9. Clip in bracket at the seat frame -1-.







Subsequent work
1. Install the front seat.