Camshaft Position Sensor: Service and Repair

WM 283919 Removing and installing hall sender

Tools





Technical values






Preliminary work

1. Remove rear wheel.
Socket-wrench insert P300 should be used to avoid damaging the rims.
=> 44051900 Removing and installing wheel.
2. Remove rear silencer.
=> 263319 Removing and installing rear silencer.
3. Remove upper part of heat shield.
=> 261219 Removing and installing heat shield.
3.1. Unscrew two M6 x 12 outer Torx screws (socket insert E10) and remove heat shield.

Removal

Removing hall sender

Hall sender on cylinder bank 1-3:
1. Remove hall sender.
1.1. Pull off cable plug -1-. To do so, press the locking lug and pull the plug downwards.
1.2. Unscrew M6 x 16 inner Torx screw (socket insert T40) -2-.
1.3. Pull out sender -3-.





Hall sender on cylinder bank 1-3

Hall sender on cylinder bank 4-6:
2. Remove hall sender.
2.1. Pull off cable plug -1-. To do so, press the locking lug and pull the plug downwards.
2.2. Unscrew M6 x 16 inner Torx screw (socket insert T40) -2-.
2.3. Pull out sender -3-.





Hall sender on cylinder bank 4-6

3. Remove old O-ring -2- on the hall sender.

Installation

Installing hall sender

1. Hold the sender -1- and slide on new O-ring -2-. Grease new O-ring with Kluber Syntheso Glep (Part No. 000.043.204.68).





Hall sender removed

2. Insert hall sender -3- into cylinder head cover.
2.1. Fit and tighten M6 x 16 inner Torx screw (socket insert T40) -2-.
=> Tightening torque: 10 Nm (7.5 ftlb.)
2.2. Connect cable plug -1-. Make sure you hear it latching into place and check that it is firmly seated by pulling on it.





Hall sender on cylinder bank 1-3

Subsequent work

1. Install upper part of heat shield.
=> 261219 Removing and installing heat shield.
1.1. Fit heat shield and screw in and tighten two M6 x 12 outer Torx screws (socket insert E10).
=> Tightening torque: 10 Nm (7.5 ftlb.)
2. Install rear silencer.
=> 263319 Removing and installing rear silencer.
3. Mount rear wheel.
Socket-wrench insert P300 should be used to avoid damaging the rims.
=> 44051900 Removing and installing wheel.