Sunroof / Moonroof Module: Service and Repair

WM 606519 Removing and installing sunroof control unit

Technical values





Preliminary work

Preliminary work for sunroof control unit

Hold rear cover underneath at the sides and carefully pull it out of the clips in -direction of arrow-.





Removing rear-wall lining

Removing sunroof control unit





Installation position

Information

- Pull out ignition key.

1. Unscrew the two fastening screws -1- and move control unit -2- first in direction -A- and then in direction -B- and set it down.





Loosening fastening screws

2. Move the slide on the electric connector in direction of arrow -C- and pull off connector -3- in direction -D-.





Removing connectors

3. Press the two connectors -4- together -E- and pull them off the control unit -F-. Fold locking lever -G- over and pull connector -5- off the control unit -H-.





Removing connectors

Installing sunroof control unit

Information

- Pull out ignition key.

1. Plug in connector -5- and fold locking lever over -G- until it engages. Plug in the two connectors -4- until they engage securely.





Plugging in connectors

2. Plug in connector -3- and close the slide in direction -C-.





Plugging in connectors

3. Push in the control unit -2- first in direction -B- and then in direction -A-. Tighten fastening screws -1-. => Tightening torque: 5.6 Nm (4.0 ftlb.)





Securing sunroof control unit

Subsequent work

Subsequent work for sunroof control unit

Position rear-wall lining and push it on in direction of arrow until the pegs of the cover clip in.





Installing rear-wall lining