Removal and Replacement
WM 170155 Changing engine oil and oil filter
Technical values
Draining engine oil
WARNING
Hot fluid
- Danger of scalding
-> Let the fluid cool down.
-> Wear personal protective gear.
Information
- Before pulling out the telescopic filler tube, always place a clean cloth over the drive belt and generator to absorb any drops of engine oil.
1. Place a clean cloth -1- over the generator and drive belt and pull the telescopic filler tube -2- out as far as it will go.
Telescopic oil filler tube
1.1. Open the cover -1- on the oil filler tube by turning it anti-clockwise.
Cover on oil filler tube
1.2. Open the cover -1- and clean the inside with a clean, lint-free cloth.
Opening oil filler cover
Information
Only use engine oils that have been tested and approved by Porsche AG.
- Dispose of waste oil in accordance with legal requirements in your country.
2. Unscrew the oil drain plug -1- at the oil pan (a/f 8 hexagon socket) and drain the engine oil into a suitable container.
Oil drain plug on oil pan
2.1. Replace sealing ring.
3. After draining the engine oil, screw in the oil drain plug -1- with a new aluminium sealing ring -2-.
Oil drain plug with sealing ring
=> Tightening torque: 50 Nm (37 ftlb.)
4. If the cover -1- is damaged, it can be unclipped from the filler tube -arrow- and replaced.
Replacing cover on oil filler tube
Changing oil filter
Information
- Never use a sharp object to remove or fit the O-ring on the oil filter cover.
- Do not scratch the sealing surface of the oil-filter housing.
The oil filter is located in the engine compartment: -1-
Oil filter cover fitted
1. Loosen the oil filter cover using a socket-wrench insert (a/f 27) -1-.
Oil filter cover
1.1. Cover adjacent components with clean cloths to prevent oil from dripping onto or into them.
2. Carefully remove the oil filter cover -2- and wipe off residual oil with a cloth -1-.
2.1. Lever off the old O-ring -3- on the filter cover using a plastic spatula.
2.2. Pull the filter element -4- out of the housing using a cloth and wrap it in the cloth.
Oil filter cover and filter element
3. Clean oil filter cover thoroughly inside and out.
3.1. Fit new O-ring and grease lightly with Kluber Syntheso Glep (Part No. 000.043.204.68).
4. Clean the oil-filter housing with a clean cloth.
5. Fit new filter element -arrow- - it can be fitted on either side.
Oil-filter housing
6. Screw in the oil filter cover and tighten to the specified torque.
Oil filter cover
=> Tightening torque: 25 Nm (19 ftlb.)
Filling in engine oil
1. Place a clean cloth over the generator and drive belt to catch any oil that overflows.
CAUTION
Incorrect oil level
- Damage to engine and catalytic converter.
-> Always observe specification for oil fill quantities.
Information
Only use engine oils that have been tested and approved by Porsche AG.
- Dispose of waste oil in accordance with legal requirements in your country.
2. Slowly pour in new engine oil using a clean container -1- or a fuel nozzle -arrow-.
Observe the prescribed filling capacity.
Filling in oil (e.g. oil fill container)
Engine oil filling capacities:
=> Filling capacity with and without filter: 7.5 liters
=> Filling capacity: 10 liters
3. Close the cover -1- and fit it at the displayed position.
Cover on oil filler tube
3.1. Tighten the cover -1- by turning it clockwise as far as it will go.
The oil pan should be horizontal when the cover is closed.
End position of cover
4. Check engine-oil level.
=> 170101 Checking engine-oil level.