Ignition Control Module: Service and Repair

WM 282019 Removing and installing ignition rod module

Tools





Technical values






Preliminary work

1. Remove rear wheel.
Socket-wrench insert P300 should be used to avoid damaging the rims.
=> 44051900 Removing and installing wheel.
2. Remove rear silencer.
=> 263319 Removing and installing rear silencer.
3. Remove upper part of heat shield.
=> 261219 Removing and installing heat shield.
3.1. Unscrew two M6 x 12 outer Torx screws (socket insert E10) and remove heat shield.

Removal

Removing ignition rod module

Component overview:





Component overview





1. Disconnect cable plug -1- by pressing firmly on the locking lug and sliding the plug upwards.
1.1. Unscrew inner Torx screw (M6 x 16) -2- and pull out ignition rod module.





View of ignition coils, side 1-3





View of ignition rod modules, side 4-6

Installation

Installing ignition rod module

1. Connect ignition rod module.
1.1. Fit inner Torx screw (M6 x 16) -2- and tighten to the prescribed tightening torque.
1.2. Connect cable plug -1-. When doing so, make sure you hear it latching into place and check that it is firmly seated by pushing it up.





View of ignition coils, side 1-3





View of ignition rod modules, side 4-6

Subsequent work

1. Install upper part of heat shield.
=> 261219 Removing and installing heat shield.
1.1. Fit heat shield and screw in and tighten two M6 x 12 outer Torx screws (socket insert E10).
=> Tightening torque: 10 Nm (7.5 ftlb.)
2. Install rear silencer.
=> 263319 Removing and installing rear silencer.
3. Mount rear wheel.
Socket-wrench insert P300 should be used to avoid damaging the rims.
=> 44051900 Removing and installing wheel.