46 Brake disc measurement sheet

WM 460000 Brake disc measurement sheet

Information

Brake disc measurement sheet

Information

Notes on checking and measurement points can be found in:

- -> 4600TW Technical data/Brake wear limit.

- Test 1 = Brake disc thickness. -> 465002 Checking front brake discs (wear assessment) and -> 46530250 Checking rear brake discs (wear assessment).

- Test 2 = Lateral runout on brake disc and wheel hub. -> 465004 Measuring front brake discs and -> 465304 Measuring rear brake discs.

- Test 3 = Thickness tolerance of brake disc. -> 465004 Measuring front brake discs and -> 465304 Measuring rear brake discs.

Information

- Actual values that are identical in all versions are already entered!

- These values can change in the course of further development. Check if necessary and add the new values accordingly. -> 4600TW Technical data/Brake wear limit.

To document the measured result, a copy or printout of the data card illustrated can be used. The data cards cannot be ordered.
1. Make a copy or printout of the data card shown.
2. Before performing measurements (Test 1 to Test 3), enter the general data, vehicle type and the missing nominal values (new brake disc thickness/brake disc wear limit) in the data card.
3. Perform measurements (Test 1 to 3, actual status) and enter the values in the data card.
4. If brake discs are to be replaced, carry out Test 2 with the new discs again and enter the latest values in a new data card.

Measuring prerequisites
- Note the labour operation numbers.
- Measuring brake discs: 80 time units per axle.