287319 Removing and installing pulse sender (speed sender)

WM 287319 Removing and installing pulse sender (speed sender)

Technical values





Preliminary work

DANGER

Vehicle can fall down

- Risk of squashing or crushing
- Risk of damage to the vehicle

-> Do not place any solid objects under the raised vehicle.
-> Ensure that the lifting platform is prevented from lowering.
-> Remove solid objects before lowering the vehicle.
-> Raise the vehicle only at the take-up points provided.
-> The outer take-up points should be used primarily.

1. Raise the vehicle.
-> 4X00IN01 Lifting the vehicle
2. Remove rear underbody panelling.
-> 519419 Removing and installing cover for rear underbody - section on "Removing" 519419 Removing and Installing Cover for Rear Underbody.

Removing pulse sender (speed sender)

1. Disconnect cable plug.





Cable plug for pulse sender

1.1. Disconnect cable plug -1- and pull it out of the holder.
2. Remove cable rail and set it aside.
2.1. Unscrew front external Torx screw (M6 x 25) -2- on the cable rail.





Front screw on cable rail

2.2. Unscrew rear external Torx screw (M6 x 20) -3- on the cable rail.





Rear screw on cable rail and screw on pulse sender

3. Remove pulse sender (speed sender).
3.1. Unscrew external Torx screw (M6 x 16) -4- on the pulse sender.
3.2. Remove the pulse sender.

Installing pulse sender (speed sender)

1. Install the pulse sender (speed sender).





Screw on pulse sender and rear screw on cable rail

1.1. Replace O-ring.
Grease and fit new O-rings with Kluber Syntheso Glep grease (Porsche Part No. 000.043.204.68).
1.2. Fit pulse sender.
1.3. Screw in and tighten external Torx screw (M6 x 16) -4- on the pulse sender.
=> Tightening torque: 10 Nm (7.5 ftlb.)
2. Install cable rail.
2.1. Screw in and tighten rear external Torx screw (M6 x 20) -3- on the cable rail.
=> Tightening torque: 10 Nm (7.5 ftlb.)
2.2. Screw in and tighten front external Torx screw (M6 x 25) -2- on the cable rail.
=> Tightening torque: 10 Nm (7.5 ftlb.)





Front screw on cable rail

3. Connect cable plug -1-.





Cable plug for pulse sender

Subsequent work

1. Install rear underbody panelling.
-> 519419 Removing and installing cover for rear underbody - section on "Installing" 519419 Removing and Installing Cover for Rear Underbody.