61401900 Removing and installing flap motor

WM 614019 Removing and installing flap motor

Preliminary work

1. Remove rear side panel flap. -> 614219 Removing and installing rear side panel - section on "Removing" Service and Repair
2. Remove microswitch for flap. -> 614119 Removing and installing microswitch for flap - section on "Removing" Service and Repair

Installing flap motor

1. Insert motor in the spindle mounting -1- and in the bracket for the rear panel flap -2-.





Inserting motor

2. Screw down motor with the four fastening screws -3-.

Information

When installing the flat connectors with the electric connecting lines, the correct installation position in the central connector (see wiring diagrams) must be observed.

3. Insert the two flat connectors with the electric connecting lines -1- in the central connector -2- -arrows- until they are felt to engage.





Making cable connections

Subsequent work

1. Install microswitch for flap. -> 614119 Removing and installing microswitch for flap - section on "Installing" Service and Repair
2. Install side panel flap. -> 614219 Removing and installing side panel flap - section on "Installing" Service and Repair