576319 Removing and Installing Rubber Seal for Door - Cabriolet

WM 576319 Removing and installing rubber seal for door - Cabriolet

Technical values





Preliminary work

1. Remove A-pillar trim. -> 705719 Removing and installing A-pillar trim - section on "Removing" 705719 Removing and installing A-pillar trim
2. Remove inner sill. -> 680519 Removing and installing inner sill - section on "Removing"

Removing rubber seal for door





Installation position of rubber seal for door

1. Unscrew fastening screw -2- and pull out rubber seal for door -1- under the cover strip -3- -Arrow A-.





Removing rubber seal for door

2. Remove rubber seal for door -1- from around the sheetmetal flange.

Installing rubber seal for door





Installation position of rubber seal for door

Information

- The rubber seal for the door must be fitted by hand.

- Pay particular attention to the areas near the tight roundings for correct installation; there must be no deformation or stretching.

- Check the air vents; they must not be closed or covered.

1. Push rubber seal for door -1- all around the sheetmetal flange.





Installing rubber seal for door

2. Push rubber seal for door -1- under the cover strip -3- -Arrow A- and screw down with the fastening screw -2-. Tightening torque => Tightening torque : 6 Nm (4.5 ftlb.)

Subsequent work

1. Install inner sill. -> 680519 Removing and installing inner sill - section on "Installing"
2. Install A-pillar trim. -> 705719 Removing and installing A-pillar trim - section on "Installing" 705719 Removing and installing A-pillar trim