696819 Removing and installing AWS control unit
WM 696819 Removing and installing AWS control unit
Preliminary work
Preliminary work for AWS control unit
Disconnect battery. -> 2706IN Work instructions after disconnecting the battery
Remove right front seat. -> 720119 Removing and installing front seat - section on "Removing" 720119 Removing and installing front seat
Removing AWS control unit
Installation position
1. Turn seat central connector -A- at AWS holder to the left and remove from the holder.
Loosening seat central connector
2. Unscrew the three fastening screws -1- for the AWS holder on the seat bracket.
Unscrewing fastening screws from AWS holder
3. Release electric connector on AWS control unit -a- , unplug and tilt the AWS holder to the right side.
4. Unscrew the three fastening screws -2- of the AWS control unit and remove the control unit.
Unscrewing fastening screws for AWS control unit.
Installing AWS control unit
1. Position AWS control unit on the holder and screw it down using the three fastening screws -2-.
Screwing AWS control unit and holder together
2. Position AWS holder on the seat bracket and screw it down using the three fastening screws -1-.
Screwing AWS holder to seat bracket
3. Push electric connector onto AWS control unit until it is felt to engage.
4. Insert seat central connector into AWS holder and clamp by turning to the right.
Subsequent work
Subsequent work for AWS control unit
Install right front seat. -> 720119 Removing and installing front seat - section on "Installing" 720119 Removing and installing front seat
Connect the battery and carry out work instructions after disconnecting the battery. -> 2706IN Work instructions after disconnecting the battery
1. If the AWS control unit has been replaced, the new AWS control unit must be taught and calibrated under AWS Control unit replacement. -> 696819 Removing and installing AWS control unit - section on "Programming" 696819 Removing and installing AWS control unit (folding sports bucket seat)-> 6968K2 Calibrating AWS control unit - section on "Calibrating" Testing and Inspection