Security Lamp/Indicator: Service and Repair

WM 968919 Removing and installing light-emitting diode for alarm system

Preliminary work

1. Remove front door panel. -> 705919 Removing and installing front door panel - section on "Removing" 705919 Removing and installing front door panel

Removing light-emitting diode for alarm system

Information

Some of the repair illustrations show only one side of the vehicle. Naturally, some steps also have to be performed on the opposite side of the vehicle as well. These must be carried out as a mirror image of the steps shown.





Installation position of light-emitting diode for alarm system

NOTICE

Voltage peaks

- Risk of damage to electrical load or to the control unit

-> Remove remote control and switch off ignition before disconnecting or removing electrical load.

1. Turn light-emitting diode holder clockwise as far as it will go -A- and pull it out -B-.





Releasing light-emitting diode holder

2. Pull off electric plug connection at the light-emitting diode holder.





Pulling off electric plug connection

Installing light-emitting diode for alarm system

1. Plug in electric plug connection at the light-emitting diode holder.





Plugging in electric plug connection

2. Position light-emitting diode holder -C- , press it in and turn it anti-clockwise as far as it will go -D-.





Locking light-emitting diode holder

Subsequent work

1. Install front door panel. -> 705919 Removing and installing front door panel - section on "Installing" 705919 Removing and installing front door panel