708319 Removing and installing roof console

WM 708319 Removing and installing roof console

Removing roof console

NOTICE

Voltage peaks

- Risk of damage to load or to the control unit

-> Switch off ignition and remove remote control before disconnecting or removing load.

Information

Always comply with the regulations for handling ESD-sensitive components!

- Assembly work must only be carried out if the mechanic is wearing the working clothes and shoes approved by Porsche.

- The new part must only be removed from the ESD (electrostatic discharge) protective packaging just before installation and at the position at which the part is to be installed.

- Never touch the electric pins and plug contacts.

1. Switch off ignition and remove remote control.
2. Unclip cover for headliner.





Unclipping cover

3. Unclip headliner at the two side cut-outs -A- and swivel it downwards -B-.





Unclipping headliner

4. Lever headliner off towards the rear.





Levering off headliner

5. Release wire harness.





Releasing wire harness

5.1. Release plug connections -a- and pull them off -B-.
5.2. Unclip fastening clip for wire harness -C-.

Installing roof console

1. Secure wire harness.





Securing wire harness

1.1. Connect plug connections -A- until they engage securely.
1.2. Clip in wire harness -B-.
2. Engage headliner at the two retaining pins.





Engaging headliner

3. Swivel in headliner and clip it into place.





Clipping roof trim panel into place

4. Clip in cover for headliner.





Clipping in cover