587319 Removing and Installing Rear Door Control Unit

WM 587319 Removing and installing rear door control unit

Tools





Preliminary work

Information

If the control unit has to be replaced, the values/coding must be read out prior to removal using the 2nd generation PIWIS Tester 9818.

-> 577355 Replacing door control unit 577319 Removing and Installing Control Unit for Front Door.

Remove rear door trim panel. -> 707319 Removing and installing rear door trim - section on "Removing" 707319 Removing and installing rear door panel

Removing rear door control unit

NOTICE

Voltage peaks

- Risk of damage to load or to the control unit

-> Switch off ignition and remove remote control before disconnecting or removing load.

Information

Always comply with the regulations for handling ESD-sensitive components!

- Assembly work must only be carried out if the mechanic is wearing the working clothes and shoes approved by Porsche.

- The new part must only be removed from the ESD (electrostatic discharge) protective packaging just before installation and at the position at which the part is to be installed.

- Never touch the electric pins and plug contacts.





Installation position of rear door control unit

1. Release electrical plug connection -1- ( -a- ) and pull it off -A-.





Disconnecting plug connections

2. Unlock the electrical plug connection -2- by pulling -b- the tab and pressing -c- the locking mechanism and pull off the connector -B-.

Information

The door control unit is fitted into the door sub-frame -1- and engaged in the door sub-frame with a locking lug -2-.





Mounting principle for door control unit

If you are unclipping the door control unit for the first time, greater force will be required in order to release the locking lug -2- from the door sub-frame.

Press the control unit backwards against the door sub-frame while you are releasing it.

3. Release the catch -A- on the control unit and remove it in the direction of the arrow -B-.





Locking hook on control unit for front door

Installing rear door control unit

1. Engage control unit for front door in the door sub-frame and clip it in.





Installing door control unit

2. Insert the electrical plug connection -1- ( -A- ) until the connector engages securely.





Connecting plug connections

3. Plug in electrical plug connection -2- ( -B- ) and lock it -a-.

Subsequent work

Install rear door panel. -> 707319 Removing and installing rear door panel - section on "Installing" 707319 Removing and installing rear door panel
1. If a new door control unit was installed, the values must be loaded into the new door control unit and the coding must be checked. -> 577355 Replacing door control unit 577319 Removing and Installing Control Unit for Front Door