Fuel Pump Control Unit: Service and Repair

WM 207019 Removing and installing control unit for fuel pump

Preliminary work

1. Remove rear right wheel. -> 440519 Removing and installing wheel - section on "Removing" Removal and Replacement

Removing control unit for fuel pump

NOTICE

Voltage peaks

- Risk of damage to load or to the control unit

-> Switch off ignition and remove remote control before disconnecting or removing load.

Information

Always comply with the regulations for handling ESD-sensitive components!

- Assembly work must only be carried out if the mechanic is wearing the working clothes and shoes approved by Porsche.

- The new part must only be removed from the ESD (electrostatic discharge) protective packaging just before installation and at the position at which the part is to be installed.

- Never touch the electric pins and plug contacts.





Installation position of control unit for fuel pump

1. Release electric plug connection -1- ( -a- ) and pull it off -A-.





Connector on control unit for fuel pump

2. Unscrew two fastening nuts -2-.





Removing control unit for fuel pump

3. Remove control unit for fuel pump from the bracket -3- ( -B- ).

Installing control unit for fuel pump

1. The control unit for the fuel pump is installed in reverse order to removal.

Subsequent work

1. Install rear right wheel. -> 440519 Removing and installing wheel - section on "Installing" Removal and Replacement