976519 Removing and installing wire harness for anti-lock brake system (ABS)

WM 976519 Removing and installing wire harness for anti-lock brake system (ABS)

Preliminary work

Preliminary work for front ABS wire harness

Remove front wheel housing liner. -> 505619 Removing and installing front wheel housing liner - section on "Removing" Service and Repair

Removing wire harness for anti-lock brake system (ABS)

Removing wire harness for front ABS





Installation position of wire harness for front ABS

1. Release electric plug connection for brake pad wear indicator -a- and pull it off -A-.





Disconnecting connector for brake pad wear indicator

2. Unclip connector for brake pad wear indicator from the bracket -B-.
3. Release electric plug connection for rpm sensor -a- and pull it off -A-.





Disconnecting connector for rpm sensor

4. Unclip wire harness from the brackets in direction of arrow -arrow-.





Unclipping front ABS wire harness from brackets

5. Release electric plug connection for connection point -a- and pull it off -A-.





Disconnecting connector for front ABS connection point

Removing wire harness for rear ABS





Installation position of rear ABS wire harness

1. Release electric plug connection for brake pad wear indicator -a- and pull it off -A-.





Disconnecting connector for brake pad wear indicator

2. Unclip connector for brake pad wear indicator from the bracket -B-.
3. Release electric plug connection for rpm sensor -a- and pull it off -A-.





Disconnecting connector for rpm sensor

4. Unclip wire harness from the bracket at the parking brake connector -1-.





Disconnecting connector for parking brake

5. Release electric plug connection for the parking brake -a- and pull it off -A-.
6. Unclip wire harness from the brackets in direction of arrow -arrow-.





Unclipping wire harness for rear ABS from brackets

7. Release electric plug connection for connection point -a- and pull it off -A-.





Disconnecting connector for ABS connection point

Installing wire harness for anti-lock brake system (ABS)

Installing wire harness for front ABS

1. Plug in electric plug connection at the connection point -A- and lock it -a-.





Plugging in connector for front ABS connection point

2. Clip wire harness into the brackets in direction of arrow -arrow-.





Clipping wire harness for front ABS into brackets

3. Plug in electric plug connection for rpm sensor -A- and lock it -a-.





Plugging in connector on rpm sensor

4. Clip connector for brake pad wear indicator into the bracket -B-.





Plugging in connector for brake pad wear indicator

5. Plug in electric plug connection for brake pad wear indicator -A- and lock it -a-.

Installing wire harness for rear ABS

1. Plug in electric plug connection at the connection point -A- and lock it -a-.





Plugging in connector for rear connection point

2. Clip wire harness into the brackets in direction of arrow -arrow-.





Clipping ABS wire harness into brackets

3. Plug in electric plug connection for rpm sensor -A- and lock it -a-.





Plugging in connector on rpm sensor

4. Clip connector for brake pad wear indicator into the bracket -B-.





Plugging in connector for brake pad wear indicator

5. Plug in electric plug connection for brake pad wear indicator -A- and lock it -a-.
6. Plug in electric plug connection for the parking brake -A- and lock it -a-.





Plugging in connector for parking brake

7. Clip wire harness into the bracket -1-.

Subsequent work

Subsequent work for wire harness for front ABS

Install front wheel housing liner. -> 505619 Removing and installing front wheel housing liner - section on "Installing" Service and Repair