397819 Removing and installing servo motor on transfer gear
WM 397819 Removing and installing servo motor on transfer gear
Preliminary work
Preliminary work for removing and installing servo motor on transfer gear
Information
If the servo motor has to be replaced, refer to the document -> 397855 Replacing servo motor on transfer gear 397855 Replacing servo motor on transfer gear.
1. Remove front cardan shaft. -> 390219 Removing and installing front cardan shaft - section on "Removing" 390219 Removing and installing front cardan shaft
Removing servo motor on transfer gear
Installation position of servo motor on transfer gear
1. Release electric plug connection on wire harness -1- for servo motor -a- and pull it off -arrow-.
Electric plug connection for servo motor
2. Release fixing clip -3- on wire harness at the servo motor -A-.
Fixing clip for servo motor
3. Unscrew fastening screws -2- at the servo motor.
Installing servo motor on transfer gear
Information
If the servo motor has to be replaced, refer to the document -> 397855 Replacing servo motor on transfer gear 397855 Replacing servo motor on transfer gear.
1. Replace sealing ring -2- on servo motor -1-.
Replacing sealing ring
2. Position the servo motor on the transmission.
3. When installing the servo motor -1- , make sure that the groove -2- on the servo motor fits into the gap -3- on the transfer gear.
Fitting servo motor
4. Screw in fastening screws -2- on the servo motor.
Installing servo motor
5. Clip in fixing clip -3- on wire harness -A-.
6. Plug in electric plug connection for servo motor wire harness -1- ( -A- ) and lock the connector -a-.
Plug connection for servo motor
Subsequent work
Subsequent work for removing and installing servo motor on transfer gear
Information
If the servo motor has to be replaced, refer to the document -> 397855 Replacing servo motor on transfer gear 397855 Replacing servo motor on transfer gear.
1. Install front cardan shaft. -> 390219 Removing and installing front cardan shaft - section on "Installing" 390219 Removing and installing front cardan shaft