205019 Removing and installing sucking jet pump

WM 205019 Removing and installing sucking jet pump

Preliminary work

1. Remove fuel level sensor at the left -> 201519 Removing and installing fuel level sensor - section on "Removing" Removal and Replacement
2. Detach and lift up the right flanges.

Information

Component information





Connection overview, lines for fuel filter





Removing sucking jet pump

1. Disconnect the sucking jet pump at the fuel pump. To do this, press on the left and right -arrows- and pull off the connections -1 and 2-.





Sucking jet pump connections at the fuel pump

2. Release connection -3- and unclip it -a-.
3. Release the sucking jet pump -1- from the bracket -2- on the fuel tank floor at the right -arrow- and unclip it.





Unclipping sucking jet pump

4. Remove the sucking jet pump through the opening in the left connection unit.





Removing sucking jet pump

Installing sucking jet pump

1. Slide the sucking jet pump into the fuel tank through the opening in the left connection unit.
2. Position the sucking jet pump -1- in the fuel tank and clip it into the holder -2-.





Clipping in sucking jet pump

3. Connect the sucking jet pump connections -1 and 2- at the fuel pump. These must lock with an audible click.





Connecting sucking jet pump connections

4. Connect the connection -3- until it engages securely.

Subsequent work

1. Fit the flange.
2. Install fuel level sensor at the left. -> 201519 Removing and installing fuel level sensor - section on "Installing" Removal and Replacement