970909 Loosening and securing main wire harness in centre console

WM 970909 Loosening and securing main wire harness in centre console

Technical values





Information

The main wire harness is manufactured individually depending on equipment.
- Fastening elements may be different from the parts described.
- The number of plug connections can vary, depending on equipment.

Preliminary work

1. Disconnect the battery. -> 2X00IN General information on disconnecting the battery Procedures
2. Remove centre console. -> 681719 Removing and installing centre console - section on "Removing" 681719 Removing and installing centre console

Loosening main wire harness in centre console

NOTICE

Voltage peaks

- Risk of damage to load or to the control unit

-> Switch off ignition and remove remote control before disconnecting or removing load.

Information

Always comply with the regulations for handling ESD-sensitive components!

- Assembly work must only be carried out if the mechanic is wearing the working clothes and shoes approved by Porsche.

- The new part must only be removed from the ESD (electrostatic discharge) protective packaging just before installation and at the position at which the part is to be installed.

- Never touch the electric pins and plug contacts.





Connector from main wire harness in centre console





1. Release and unplug electric plug connection -10- on airbag control unit. -> 695319 Removing and installing triggering unit for airbag - section on "Removing" 695319 Removing and Installing Triggering Unit For Airbag
2. Unscrew fastening nut from ground point -13- in the centre console.
3. Release and unplug electric plug connection -14- for combination sensor. -> 456155 Replacing combination sensor Service and Repair
4. Unscrew fastening screws -1- on brackets and remove the brackets -2-.





Removing brackets for centre console

5. Release wire harness from the cable duct -3-.

Securing main wire harness in centre console





Connector from main wire harness in centre console





1. First lay the main wire harness loosely in the centre console, ensuring that it is positioned correctly.





Removing brackets for centre console

2. Fit wire harness into the cable ducts -3- and clip on the cover.
3. Fit brackets -2- for centre console.
4. Tighten four fastening screws -1- on the brackets -2- to => Tightening torque: 8 Nm (6 ftlb.).
5. Tighten fastening nut on ground point -13- in centre console to => Tightening torque: 9 Nm (6.5 ftlb.).
6. Plug in electric plug connections -10 + 14- until they engage securely.

Subsequent work

1. Remove centre console. -> 681719 Removing and installing centre console - section on "Removing" 681719 Removing and installing centre console
2. Connect the battery. -> 2X00IN General information on disconnecting the battery Procedures