927019 Removing and installing cover for spray nozzle

WM 927019 Removing and installing cover for spray nozzle

Removing cover for spray nozzle

Information

Some of the repair illustrations show only one side of the vehicle. Naturally, some steps also have to be performed on the opposite side of the vehicle as well. These must be carried out as a mirror image of the steps shown.





Installation position of cover for spray nozzle

1. Disengage cap on nozzle head.
1.1. Front apron installed: Grasp the spray nozzle cover at the sides; the nozzle head -1- must then be pulled out -A- and held.
1.2. Disengage the cap -2- at the latches of the nozzle head -1- ( -B- ) and remove it.





Disengaging cap on nozzle head

Installing cover for spray nozzle

Information

If the cover of the spray nozzle has to be replaced, the new part must be painted the same colour as the front apron.

1. Engage cap on nozzle head.
1.1. Pull the nozzle head -1- out of the front apron -A- and hold it.
1.2. Engage the cap -2- at the latches on the nozzle head -1- ( -B- ).





Engaging cap on nozzle head

2. Slide nozzle head and cover into the locking teeth on the spray nozzle.
3. Release spray nozzle and check the gap to ensure that the spray nozzle cover is positioned evenly all the way round.