9903519 Removing and installing gateway control unit

WM 903519 Removing and installing gateway control unit

Technical values





Preliminary work

1. Remove rear left part of C-pillar trim.-> 706819 Removing and installing C-pillar trim - section on "Removing" 706819 Removing and installing C-pillar trim

Removing gateway control unit

1. Loosen the two fastening nuts -1- on the gateway control unit and remove the control unit.





Removing gateway control unit

2. Release electric plug connection -a- and pull it off the control unit.





Pulling off electric plug connection

Installing gateway control unit

1. Connect the electrical plug, pressing on until it clicks into place.





Connecting electrical plug connection

2. Position the control unit and secure with the two fastening nuts -1-.=> Tightening torque: 2 Nm (1.5 ftlb.)





Installing gateway control unit

Subsequent work

1. Install rear left part of C-pillar trim. -> 706819 Removing and installing C-pillar trim panel - section on "Installing" 706819 Removing and installing C-pillar trim