466219 Removing and installing control unit for electric parking brake

WM 466219 Removing and installing control unit for electric parking brake

Tools





Preliminary work

1. If the control unit for the electric parking brake has to be replaced, the values must be read out prior to removal using the 2nd generation PIWIS Tester 9818. -> 466255 Replacing control unit for electric parking brake 466255 Replacing control unit for electric parking brake.
2. Remove right C-pillar trim. -> 706819 Removing and installing C-pillar trim - section on "Removing" 706819 Removing and installing C-pillar trim

Removing control unit for electric parking brake

NOTICE

Voltage peaks

- Risk of damage to load or to the control unit

-> Remove the ignition key and switch off load before disconnecting or removing load.





Arrangement of control unit for electric parking brake

1. Switch off ignition and remove remote control.
2. Unscrew the two fastening screws -1-.





Mounting point for control unit for parking brake

3. Release the plug connection -a- and pull it off -A-.





Disconnecting plug connection

Installing control unit for electric parking brake

1. Connect -A- and lock -a- the plug connection.





Connecting plug connection

2. Place control unit for electric parking brake in installation position.
3. Secure the control unit with the two fastening screws -1-.





Mounting point for control unit for parking brake

Subsequent work

1. If the control unit for the electric parking brake was replaced, the values must be written using the 2nd generation PIWIS Tester 9818. Reference to 466255.
2. Install right C-pillar trim. -> 706819 Removing and installing C-pillar trim - section on "Reworking" 706819 Removing and installing C-pillar trim