370819 Removing and installing selector support

WM 370819 Removing and installing selector support

Tools





Technical values





Preliminary work for selector support

1. Remove selector knob. -> 370419 Removing and installing selector knob - section on "Removing" 370419 Removing and installing selector knob
2. Remove centre console. -> 681719 Removing and installing centre console - section on "Removing" 681719 Removing and installing centre console

Removing selector support

1. Remove insulating material on selector support.





Selector support insulating material

2. Press locking cable off the selector lever on the transmission using disassembly tool Nr.21.





Removing locking cable

3. Press the pendulum joint on the locking cable upwards and pull to the rear and out of the support.





Removing cable from support

4. Disengage and pull off cable plug on selector support.





Cable plug for selector support

5. Remove fastening screws for selector support and remove selector support.





Fastening screws for selector support

Disassembling selector support

Information

A new bottom part of the selector support must be used after disassembling the selector support as the fastening screws are screwed into the housing itself.

1. Unscrew fastening screws for top part of selector support.





Mount for top part of selector support

2. Remove top part of selector support and detach driving pin from end of operating cable -arrow-.





End of operating cable

3. Remove locking cable tab washer.





Locking cable tab washer

4. Remove locking cable.

Installing selector support

Assembling selector support

1. Insert locking cable into the lower part of the selector support.
2. Install tab washer for operating cable.





Operating cable tab washer

3. Place selector support onto the new lower part of selector support. At the same time, insert driver into the end of the operating cable -arrow-.





End of operating cable

Information

A new bottom part of the selector support must be used after disassembling the selector support as the fastening screws are screwed into the housing itself.

4. Screw in fastening screws -arrows- for selector support.





Mounting for upper part of selector support

5. Loosen adjusting screw -arrow- in the selector support by a maximum of one turn.





Adjusting screw for locking cable

Installing selector support

1. Move selector lever on the transmission to position P, the highest position.





Lever on transmission

2. Insert selector support with locking cable through the opening in the tunnel.
3. Push the pendulum joint on the locking cable into the support on the transmission in direction of travel.





Locking cable on support

4. Press locking cable onto the ball head on the transmission.





Fitting locking cable

5. Screw in fastening screws -1- for securing selector support to body. => Tightening torque: 10 Nm (7.5 ftlb.)





Fastening screws for selector support

6. Move selector support to position P, all the way to the front.

Information

When tightening, the fastening screw must not be pushed in the longitudinal direction.

7. Tighten adjusting screw -arrow- for the locking cable in the selector support. => Tightening torque: 10 Nm (7.5 ftlb.)





Adjusting screw for locking cable

Subsequent work for selector support

1. Install centre console. -> 681719 Removing and installing centre console - section on "Installing" 681719 Removing and installing centre console
2. Adjust locking cable. -> 371315 Adjusting locking cable Adjustments
3. Install selector knob. -> 370419 Removing and installing selector knob - section on "Installing" 370419 Removing and installing selector knob