5000IN Using 2K acoustic filler foam "AFS-Vario

""

WM 5000IN Using 2K acoustic filler foam "AFS-Vario" on the body

Using 2K acoustic filler foam "AFS-Vario" on the body

Description

The 2K acoustic foam filler "AFS Vario" is a ready-to-use, expanding filler and insulating foam that comes in an aerosol can. It is expanding, extremely tacky and gives good results. A longer skin formation time means that the processing time is around 15-18 minutes. Processing can be interrupted briefly at up to approx. 5 minutes. The chemical reaction is generally complete after about 30 minutes. The hardened filler does not swell or shrink.

Applications

The 2K acoustic foam filler "AFS Vario" is ideal for filling, insulating and sealing cavities , e.g. A-, B-, C-pillar, door sills and frame sections.

Processing

Information

Always observe the relevant work safety regulations when working with the foam filler.

WARNING

Toxic substances
- Danger of poisoning or suffocation

-> Ventilate the work area well.
->Never ingest or inhale.
->Read specific information on the Hazard Sheet.
->Wear personal protective gear.

Information

The work area must be free of dust and grease.

Remove loose parts.

Do not wet the area beforehand.

Observe temperature limits:
- Can and ambient temperature: 10-35°C

- Optimal temperature: 18-23°C

Information

Apply sparingly since the volume of the foam filler will expand by approx. 50-100 % in open areas and by approx. 100-200 % in cavities. Approx. 0.25 litres of foam volume is produced per second of foam time (free-foaming). The foam filler is silver-grey. Remove fresh foam residues immediately with PU cleaner. Hardened foam residues can only be removed mechanically afterwards. Always remove foam from the can following activation.

- Activation process:
- 1. Break open the seal on the activation lid.
- 2. Use a piece of wire to pull the activation lid out as far as it will go (approx. 11 cm up to the notch).
- 3. Break off the wire at the required rupture point (notch) over the valve.
- 4. Screw plastic adapter into the valve.
- 5. Shake can vigorously up and down (approx. 20 times).
- 6. Release foam downwards out of the can with the valve.
- Subsequent work:
The hardened foam filler can be processed further by sanding, cutting or sawing. It can be painted or varnished immediately.

-------------------------------------------------------------------------------

987110, 987111, 987120, 987121, 987140, 987141, 987160, 987161, 987310, 987311, 987320, 987321, 987330, 987340, 987360, 987361, 987371, 987381, 987720, 987721, 987740, 987741, 987130, 987180, 987181, 987350, 987760, 987761, 987780, 987781

Model year as of 2005
C00, C02, C05, C07, C08, C09, C10, C11, C12, C13, C14, C15, C16, C18, C19, C20, C21, C22, C23, C24, C25, C26, C27, C28, C32, C33, C34, C35, C36, C37, C38, C39, C45, C46, C98, C99