Faulty

P050600

Diagnostic information - DME control unit

Faulty

The control unit must be active in order to test internal function sequences and diagnosable inputs/outputs.
In the event of a fault, check whether the fault is permanently >present<. To perform the check, erase the fault memory, meet the diagnostic conditions and read out the fault memory again.

NOTE:
- Internal faults in DME control unit
- It is possible that the engine will be switched off
- Engine no longer starts

Diagnostic conditions
- Supply voltage: Less Than +9 V , Greater Than +15.5 V

Possible fault causes
- Supply voltage, limit value exceeded
- Supply voltage, below limit value
- Processor faulty