With LH System Tester

Fault codes: LH 2.4 (35-pin connector)

The following fault codes are used for the LH 2.4

Fault Pin No. Malfunction indicated
code
E001 1 No ignition pulse on pin 1
E101 1 Starter motor revs too low
E002 2 Idling contacts constantly open
E102 2 Idling contacts constantly closed
E003 3 Throttle position switch contacts constantly open
E103 3 Throttle position switch contacts constantly closed
E005 5 Control module pin 5 not grounding
E006 6 Mass air flow sensor not grounding
E007 7 Mass air flow sensor, no signal
E107 7 Mass air flow sensor signal too high
E207 7 Mass air flow meter signal too low
E008 8 Mass air flow sensor, no burn-off function
E108 8 Mass air flow sensor, burn-off function constantly activated
E009 9 Main relay, no 12 V supply
E109 9 Main relay, 12 V supply too low
E018 18 No injection pulses
E118 13 Injection pulses erratic
E020 20 Pump relay control circuit faulty
E021 21 Main relay control circuit faulty
E024 24 Lambda sensor, no signal
E124 24 Lambda sensor signal too high
E224 24 Lambda sensor signal too low
E025 25 No load signal
E033 33 IAC valve, no signal from pin 33
E035 35 No +15 supply

The following may also appear on the tester display:

"GLOU" Mass air flow meter filament (hot-wire) burn-off function
"C 6" Non-turbo engines with IAC and catalytic converter
"F PU" Fuel pump relay and main relay operated
"FUEL" Fuel mode
"OFF" Starting point for injector test
"F IN" Injectors open
"MON" Monitor mode