Filling the 5-Speed Gearbox

FILLING WITH OIL AFTER REPAIR OR RECONDITIONING OF THE GEARBOX
Pour 0.3 litres of oil into the primary chaincase through the cover in front of the clutch shaft end. Pour the remaining 2.7 litres of oil into the gearcase. About 2.6 litres of oil are needed before oil will overflow through the hole into the primary chaincase. The lowest point of the overflow hole is level with the MAX mark on the dipstick.

Oil
Engine oil is used for lubricating the transmission system. The oil should be changed during the 2000 km service, and then only after repair or reconditioning of the gearbox. Use the oil recommended in the specification for topping up. Use the dipstick on the right-hand side of the gearbox for checking the oil level.