Blower Motor Switch: Service and Repair

NOTE: Models within VIN Serial No. Range: N1000001 - S1005461, inclusive refer to the "Technical Service Bulletin" No. 10950633 for information on Fan Control/Fan Resistor modification.

Removal:
1. Remove the rubber strip and the cover over the bulkhead space. Disconnect the washer hose.
2. Free the right-hand shield plates.
3. Unplug the connector and undo the three securing screws. Lift away the fan control module.

CAUTION: The fan control module cooling fin is live until the connector is unplugged.

Installation
1. Fit the control module.
2. Plug in the connector.
3. Fit the shield plates.
4. Connect the washer hose to the cover and secure the cover and the rubber strip over the bulkhead partition space.
5. Calibrate the ACC system by pressing the "AUTO" and "VENT" buttons at the same time.

NOTE: During calibration, all previously stored diagnostic trouble codes are erased. Before carrying out calibration, all stored diagnostic trouble codes should be read.