Fog/Driving Lamp: Adjustments

1 Measure the distance between the center of the lens and the floor.
Mark the wall (at 90° to the lens) with a cross at the same height.
2 Switch on the fog lights.
3 Turn the adjusting screw until the light is:
- (for the US market) about 1.3% of the distance between the car and the wall (e.g. 13 cm below the cross if the distance between car and wall is 10 metres).
- (for other markets) about 2% of the distance between car and wall (e.g. 20 cm below the cross if the distance between car and wall is 10 metres).

angled downwards below the horizontal line of the cross.






Check the following points before carrying out adjustment:
- Check the tire pressures.
- Check that the car is weighted with a normal load.
- Check that the bulbs are correctly installed.

Position the car at right angles to the headlamp aligning equipment.

Lateral adjustment
The headlamp alignment adjusting screw (hexagonal) is easily accessible from above through a hole in the radiator member.

Important : The beam-length adjustment control should be set to 0 when aligning the headlamps.

Vertical adjustment
Carry out vertical adjustment by means of the knob on the actuator motor, which will take the new setting as the starting point for beam-length adjustment.