B1610

Diagnostic trouble code B1610 - Control module incorrectly programmed

���:

1. Switch on the ignition and erase the diagnostic trouble code.Switch off the ignition and switch it back on again. Wait for at least 10 seconds with the ignition on. Check to see if the diagnostic trouble code returns.
If the diagnostic trouble code returns: Proceed to point 2.
If the diagnostic trouble code does not return: No action.

2. Connect ISAT Using the ISAT, check if the SRS control module is programmed for one or two airbags and compare this with the actual number of airbags in the car.
If the number is OK: If there are other diagnostic trouble codes stored, take action on these first.
If there are no other diagnostic trouble codes stored, Description of On-Board Diagnostics
If the number is not OK: Program the correct number of airbags using the ISAT Programming, Command Menus