Idle Speed/Throttle Actuator - Electronic: Service and Repair

To Remove
1. Remove the throttle body's rubber hose elbow.
2. Remove the retaining clip and bend aside the throttle cable guide.
3. Disconnect the idle air control valve's hoses from the throttle body.
4. Pull the valve out of its holder and remove the hoses.
5. Unplug the valve's connector.
6. Lift out the valve and remove the two hoses.

Fit In Reverse Order.

IMPORTANT: Do not tighten any of the four hose clips until the valve has been fifted in its holder and correctly positioned.