4:2 Automatic Transmission - A/T, Selector Lever

4:2 Automatic transmission - automatic transmission

Technical data, Settings, page 6





The table has been changed.

B205F/B205E/B235E

P0748 Fault diagnosis, diagnostic trouble codes, page 110

Pressure control solenoid

Point 3/Is function correct?

Under YES, the instruction is to change the pressure control solenoid. Due to the warranty agreement with the manufacturer, gearbox components must not be replaced. Change the complete gearbox instead.

WINTER and SPORT, mode not functional, Fault diagnosis, fault symptom, page 141

Point 1.

The test lamp should be connected between B+ and pin 2 in the female connector H6-4.

Adjustment and replacement, complete gearbox, page 152 Under the heading "To fit" point 28, add the following warning box:

WARNING
Check that the spindle on the ball joint protrudes above the steering swivel member attachment.

4:2 Automatic transmission - selector lever

Adjustment and replacement, gear selector cable, page 213 Under the heading "To check and adjust" point 6, add the following text as an introduction:

"Push the gear selector level back and press down the adjustment clamp..."