Programming and Relearning

Electronic Brake Control Module Programming and Setup

EBCM Replacement

If the electronic brake control module (EBCM) is replaced, the following procedures must be performed:

* EBCM Reprogramming-Refer to Service Programming System (SPS) (Service Programming System (SPS)).
* Revise the tire calibration using the Scan Tool Tire Size calibration function.

EBCM Reprogramming

If the EBCM needs to be reprogrammed, refer to Service Programming System (SPS) (Service Programming System (SPS)).

Yaw Rate Sensor/Lateral Accelerometer Replacement

Replace the EBCM after replacing the yaw rate sensor/lateral accelerometer, and reprogram EBCM.

* EBCM Reprogramming-Refer to Service Programming System (SPS) (Service Programming System (SPS)).
* Revise the tire calibration using the Scan Tool Tire Size calibration function.