Pusher Fan

REMOVAL





1. Disconnect negative battery cable.
2. Disconnect pusher fan electrical connector.
3. Remove pusher fan harness from puller fan shroud tabs and push harness clear of radiator end tank.

CAUTION: MAKE SURE VEHICLE IS PROPERLY SUPPORTED AND SQUARELY POSITIONED. TO HELP AVOID PERSONAL INJURY WHEN A VEHICLE IS ON A HOIST, PROVIDE ADDITIONAL SUPPORT FOR THE VEHICLE ON THE OPPOSITE END FROM WHICH COMPONENTS ARE BEING REMOVED.





4. Raise vehicle
5. Remove pusher fan to condenser retaining washers and nuts.





6. Pull lower fan shroud forward and then down to remove.





7. Remove finger guard by depressing tabs at four locations.

INSTALLATION





1. Snap new finger guard onto pusher fan.
2. Slide upper pusher fan shroud under retaining tabs located at upper edge of condenser.

NOTICE: Position pusher fan electrical harness in shroud indentation to prevent harness damage.





3. Rotate lower fan shroud onto condenser mounting studs and install retaining washers and nuts.
^ Torque: 4 Nm (35 inch lbs.)





4. Route pusher fan electrical harness around outside of radiator end tank, below upper radiator hose.
5. Lower vehicle.
6. Install pusher fan harness into mounting tabs on puller fan shroud.
7. Connect pusher fan electrical connector.
8. Connect negative battery cable.
^ Torque: 17 Nm (13 ft. lbs.)