Bracket Replacement - Instrument Panel (I/P) Center Support
BRACKET REPLACEMENT - INSTRUMENT PANEL (I/P) CENTER SUPPORT
REMOVAL PROCEDURE
1. Remove the front floor console.
2. Remove the wiring harness rosebud from the center support bracket.
3. Pull back the carpet at the bottom of the center support bracket and remove the center support bracket lower nuts.
4. Remove the center support bracket nuts and remove the bracket.
INSTALLATION PROCEDURE
1. Pull back the carpet and position the center support bracket into position.
2. Install the center support bracket nuts.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the center support bracket nuts to 10 N.m (88 lb in).
3. Install the wiring harness rosebud to the center support bracket.
4. Install the front floor console.