63. Camshaft Position Sensor Housing Installation

Camshaft Position Sensor Housing Installation





1. Rotate the crankshaft until number 4 piston is at top dead center (TDC) on the compression stroke. Refer to the crankshaft damper-to-front-cover timing marks.
2. Install a NEW camshaft position sensor housing seal.





3. Align the timing mark on the housing with the timing mark on the hex shaft.





4. Install the camshaft position sensor housing.

Notice: Refer to Fastener Notice in Service Precautions.

5. Install the camshaft position sensor housing studs.
Tighten the camshaft position sensor housing studs to 22 Nm (16 ft. lbs.).